How to use the wood pellet machine! (introduction)

March 24, 2024

Many wood chip machines that users buy back do not know the specific operation method. The following is answered by Maoxiang technicians:

1. The long-term operation of the wood pellet machine should be fixed on the cement foundation. If the working place is changed frequently, the chip granulator and the motor should be installed on the base made of angle iron. If the wood pellet machine is powered by diesel, the power of the two should be matched, that is, the diesel power is slightly larger than the power of the crusher, and The pulley grooves of the two are the same, and the outer end faces of the pulley are on the same plane. 　　

2. After the wood chip machine is installed, check the fastening condition of each fastener. If it is loose, tighten it. 　　

3. Check if the belt tightness is appropriate and whether the motor shaft and the wood chip machine shaft are parallel. 　　

4. Before starting the wood pellet machine, first turn the rotor by hand to check whether the teeth, hammer and rotor are running flexibly and reliably. There is no collision in the shell. The rotation direction of the rotor is consistent with the direction indicated by the arrow on the machine. Whether the wood pellet machine is well lubricated. 　　

5. Do not change the pulleys casually, in case the rotation speed is too high, the explosion chamber will explode, or the rotation speed is too low, which will affect the working efficiency. 　　

6. After crushing station starts the first 2 or 3 minutes idling, no abnormal phenomenon feeding after work. 　　

7. Pay attention to the operation of the wood pellet machine at work, and the feeding should be even to prevent the car from being blocked and not overloaded for a long time. If vibration, noise, high temperature of the bearing and the body, and external spraying are found, stop the machine immediately and continue working after troubleshooting. 　　

8. The crushed materials should be carefully inspected to prevent accidents such as copper, iron, stones and other hard objects entering the crushing chamber. 　　

9. The operator should not wear gloves. When feeding, stand on the side of the wood pellet machine to prevent the rebound debris from injuring the face.

With the above correct use method, it will provide you with greater convenience, and look forward to your joining and purchasing!

पिछला

अगले

संपर्क करें

Author:

Mr. Qinghu Ge

ईमेल:

yulong@yljx168.com

Phone/WhatsApp:

+86 15662799493

लोकप्रिय उत्पाद

कंपनी समाचार